Notifications

Another cheap target holder  

  RSS

JiminPGH
( @jiminpgh )
Joined: 2 years ago
Posts: 426
2019-09-21 18:43:12  

Scrap CPVC from a worksite, some binder clips, and some aluminum barstock I had laying around. Knocks down for transport, and holds 8 1/2 x 11 sheets.  The bottom spreader is a rip of 3/32 plywood.

IMG 8833 1
IMG 8832 1
IMG 8831 1
IMG 8830 1

I also make my own shoot-n-see targets.  Astrobrights cardstock from Walmart, covered in clear plastic packing tape, then sprayed with flat black paint, the cheaper the better.  "Project" spraypaint is cheapest and best for this application.


TomR_here and pluric thanked
Quote
BillK
( @billk )
Joined: 2 years ago
Posts: 12
2019-09-21 21:58:49  

I like it.  Will try it.

Thanks, Bill


ReplyQuote
CarlosMendez
( @carlos-hombre )
Joined: 2 years ago
Posts: 83
2019-10-23 11:35:48  

I use H-Stakes from campaign signs after an election. Tape a target to the sign and shoot until it is shot up, then replace with a piece of corrugated card board.  I usually ask the candidate and they are always glad to have help removing these signs after the election is over.

https://ibb.co/LChmHVZ


ReplyQuote