Ataman BP-17 (World's Shortest Bullpup)

Little rascal costs $1399.99, which, in my opinion, is very close to $1400.  

I'd like to know what weight pellets they used to get the claimed 850 fps and 25 fpe, that, if accurate, is quite respectable for it's size. 

Further, wondering if the claimed 25 shots per fill is still valid at the claimed 850 fps/25 fpe?  

Regards,

Kindly 'Ol Uncle

I noticed Ataman Prices being further discounted at PA making them

even cheaper to buy than from Krale.

Hopefully this Bullpup drops to $899 like other Atamans recently!

You can get them cheaper buying refurbished too.

HA

I got many refurbished guns from PY Air. They were always like new. I actually got my black AP16 refurbished for $750 a couple years ago. 

....I’m just going to let you know...I may have to settle the regulator with 500 rounds. But the BP-17  shoots like crap now....accurate but with 6-8 inch off flyer about every 4-5 shots. I even shot my new $600 Galaxy S8 right through the heart because of the aforementioned crap shooting. 

I suspect I just need to “setttle” the regulator. That was the case with the Fortitude which went from 2 inch groups to 1/2 inch groups with the same exact pellets after exactly 500 rounds. I heard even FX impacts need the regulator “settled” before they will shoot their best. 

Also, the safety fell completely out of the gun as soon as I started shooting it. My M2 the safety and the hole in the stock do not line up...so it can not be pushed off and on. 

THEY OBVIOSLY DON’T CHECK ATAMANS TO SEE IF THEY FUNCTION CORRECTLY BEFORE THEY LEAVE THE FACTORY. 

...time will tell on the BP17

Seriously doubt the regulator not yet broken in would cause a 6" drop. IF you were sighted in shooting 25yds and the pellet is flying at 800fps it would take a drop of over 100fps to cause a 6" poi.

At 25, 35, 50, and 61 yards it would shoot 1-2 six inches high, not low, about every 5 shots. It did that all day...but I was starting auto 220 bar. That was with all different pellets. 

I'd be looking at the crown or the moderator for clipping.