8mm Hatsan shotgun mod
WELL IM FINALLY FINISHED
Modifying a MOD 130S Vortex QE Breakbarrel it is a smooth bore 8mm shotgun. Here's some of the ammo. A paper casing. Holding 47.3 grains of shot The casing weight is 1.7
My concept is from the civil war. Buck and ball loads. But has been modified I also use it in my 28 ga Muzzleloader shotgun, the sabots are larger and use heavier gauge paper casing.
The cartridge is a thin piece of tubing made to 8mm there is a wad in the breach end. The case is cut in ten places around the top for crimping. They are filled with shot. Then they are crimped and a small drop of dopp wax keeps the crimp closed.
When the gun is fired it compresses the wad splitting the paper casing and opens the crimp. The barrel is slightly choked further opening the casing as it leaves the barrel
I had made some sabots in the 7.62 pellet size they shoot well in the rifled barrel of my MOD 130S Vortex QE and have a good spread up to about 30 or so feet more than that it will probably be ineffective.
Purchased another MOD 130S Vortex QE Breakbarrel to modify. My other is broke in and it's very fun to shoot.
I will be updating all of you soon on the progress, testing etc of my project shotgun.
@tripleguy, I have a 50 cal. tranqualizizer dart gun. I have shot 178 grain .495 lead balls out of it, at 40 yards the balls have about 12-13 " of drop, I wondered if a charge of shot would shoot flatter at the same distance, because the individual pellets have less mass than the .495 ball ? TIA