RAW Tm 1000 power a...
 

RAW Tm 1000 power adjustment question  

  RSS

Rick Vaeth
(@rick)
Joined: 2 years ago
Posts: 28
2019-09-21 16:08:27  

I picked up a used TM 1000 and have been adjusting the power using the screw on the back of the block. Because I have an older model I have to remove the stock. Noticed a screw on the front bottom of the block. What does this do? Thanks Rick 


Quote
Motorhead
(@motorhead)
Member of Trade
Joined: 4 months ago
Posts: 63
2019-09-21 21:42:58  

The RAW mono-block receiver consists of these external adjusters or covers:

Rear of block:

Cocking mechanics on top, grub screw and pivot screws to contain it.

Under that the hammer spring tension adjuster.

 

Bottom of block:

Cover screw / plate that allows use of a plenum pressure tester, covers the drilled passage from reg /plenum space to the valve chamber.

 

Forward / barrel end of block:

Top the barrel hole

Below that the cover over valve components

Below that where regulator or fast flow inlet screws in and the plenum space.

 

 

Home of ... MOTORHEADS AG TUNING SERVICES
................... @ Northern California USA ....................
Sacramento Valley Field Target Club SVFTC Scott S


ReplyQuote
Rick Vaeth
(@rick)
Joined: 2 years ago
Posts: 28
2019-09-22 10:10:55  

Thank you for the information. Motorhead 


ReplyQuote

Please Login or Register